Finite element modelling of cutting force components in face milling

Authors

  • Csaba Felhő University of Miskolc

DOI:

https://doi.org/10.35925/j.multi.2020.1.15

Keywords:

Finite Element Modelling, Face milling, Cutting force components

Abstract

This paper presents a study about the Finite Element Modelling of cutting force components acting on the workpiece (Fx, Fy, Fz) in face milling. The values of the three force components were simulated by the FEM software AdvantEdge by Third Wave Systems. This program is uniquely intended for modelling of cutting processes. The simulated cutting force values were compared with real measurement data, and a good correlation was between them.

Downloads

Published

2020-04-26